Readylift kit + 2" suspension lift

[Nav_brah]

Yeah there is quite a bit of drop when i jack it up. thats when the swar bar connector pops off. I think ill need to hammer the top of the bucket in a bit to give more room. can you post a pic of the after affects of your hammering of the bucket??

also how is your UCA set accoridng to this http://www.spcalignment.net/instructions/25540-INS_WEB.pdf

 

[camo.b]

Im set to D.
Ive trimmed a bit off and hammered a little bit somwhere.

 

[Nav_brah]

Fuarrrk man that looks like a pain in the ass to do. Solid steel to be tough to cut...

 

[camo.b]

If u have enough clearance here u dont have to worry.if it like mm away from the boot...cut it or just hammer it down..remember just the lip on the bucket..if i was to do it again i would hammer it down.easest was is to drop the top ball joint off and push it up and out the way.

 

[Nav_brah]

Thanks for the help Camo...im going to cut away some of the bucket next weekend to allow for downward movement. Ill report back with results.

 

[camo.b]

Id check in asap to make sure the ball joint boot isnt being damaged...there was another bloke on here that got a shop to fit his spc arms...didnt check the fitting instructions and ripped a big hole in the boot.

 

[Nav_brah]

Id check in asap to make sure the ball joint boot isnt being damaged...there was another bloke on here that got a shop to fit his spc arms...didnt check the fitting instructions and ripped a big hole in the boot.

fuark man ill check it out doesnt look like its that close but it is close to touching.... scaring me now.