Wiring into engine bay

[Jased22]

Pic of drivers side above pedal assembly. No room. No grommet near clutch

 

[Jased22]

Well been quoted $150 to get it all installed

 

[Jased22]

Fu#k yeah!!!!

 

[bods]

Nice job. How bright are they at night?

 

[Jased22]

Havent seen them at night yet. I will post a pic of them lit up a bit later. They dont seem to bright though, not like the cobalt gauges

 

[bods]

Cool. I have c2's in mine and they were as bright as all hell. I put resistors in on the light feed to dim them down a bit. Chuck up some pics when you can.

 

[Jased22]

They are alot brighter then the dash lights but they dont put out to much light. The background is darker then it looks in the pics

 

[bods]

Looks good to me. At least you didn't have to do it yourself haha

 

[Jased22]

Haha yeah I'd rather get it done properly, I would of fu@ked something up

 

[Jased22]

Cool. I have c2's in mine and they were as bright as all hell. I put resistors in on the light feed to dim them down a bit. Chuck up some pics when you can.

What do the c2's look like at night?

 

[bods]

That's with resistors in. They were a hell of a lot brighter before putting them in. They've been in around 3 and a half years now without any problems.

Should have said, they look a lot brighter in the pic than what they actually are too

 

[Jased22]

Oh yeah they look good. See how I go on long drives. Might need to put a resistor in

 

[bods]

Yeah, that's the best bet, see how you go. I couldn't even see out the windscreen originally they were that bright lmao.

 

[Jased22]

Haha dont know why they make them so bright

 

[bods]

Can't work that out hey lol. Maybe if you wear sunnies at night haha. They might be ok with a dimmer switch, but not at full brightness.