My results are in..... Can the d22 be chipped from chip it, answer yes. Is it the same results as they post, not quite. I put the challenge to chip it and here r the results. My car standard with snorkel and egt block off, my dyno results were 73kw at wheels with 343 nm torque. After Andrew from diesel tech in lilydale custom tuned it I got 90 kw at the wheel with a huge 453 nm torque. The thing is, it's no 110kw like I was told or shown but if I didnt know I would believe I had 110. The improvement the chip has made is very impressive. I was manly after extra torque which I most certainly got. To answer the question about low down torque it's better but not terrific but once u get the revs up to 1500 revs ur on ur way. Andrews been able to generate the 453nm torque at 2500 therefore towing the boat is easy without reving out no use going over 3000 rpms. I have a Haines hunter 495 breeze and I started off at the bottom of the hill and I got to the top revving out to 3000 in fouth. In conclusion the hill near my house I mentioned in an earlier post, I now hold 100kh in fifth all the way up the hill and that was all I was after. If this is the power 90kw gives u, that's enough. I feel any more would be a waste not to mention damaging. Andrew from diesel tech phone no. 03 9739 5031. With all that said and done I am now a happy customer of chip it and now I am confident in buying and towing a new two tonne boat......
Don't worry about the exact numbers not matching, every dyno throw's out a different number, depending on tyre pressures, diff ratio, gear selected, air temp etc. Just work out the percentage increases to see if your money was well spent.
My results are in..... Can the d22 be chipped from chip it, answer yes. Is it the same results as they post, not quite. I put the challenge to chip it and here r the results. My car standard with snorkel and egt block off, my dyno results were 73kw at wheels with 343 nm torque. After Andrew from diesel tech in lilydale custom tuned it I got 90 kw at the wheel with a huge 453 nm torque. The thing is, it's no 110kw like I was told or shown but if I didnt know I would believe I had 110. The improvement the chip has made is very impressive. I was manly after extra torque which I most certainly got. To answer the question about low down torque it's better but not terrific but once u get the revs up to 1500 revs ur on ur way. Andrews been able to generate the 453nm torque at 2500 therefore towing the boat is easy without reving out no use going over 3000 rpms. I have a Haines hunter 495 breeze and I started off at the bottom of the hill and I got to the top revving out to 3000 in fouth. In conclusion the hill near my house I mentioned in an earlier post, I now hold 100kh in fifth all the way up the hill and that was all I was after. If this is the power 90kw gives u, that's enough. I feel any more would be a waste not to mention damaging. Andrew from diesel tech phone no. 03 9739 5031. With all that said and done I am now a happy customer of chip it and now I am confident in buying and towing a new two tonne boat......
Hi Chip It,
I have a pre common rail 2003 zd30 which has told me it is very keen to be your donor vehicle for the fitting and dyno testing. If the offer still stands im also very keen to get this mod done, I'm off work till thurs this week, PM me for my phone number and we can meet up. Will
Enter your email address to join: