D22 ZD30 2004 Replaced DI pump. Stuck in limp mode

[Scott127651]

Hi,

Hoping for some advice. Mechanic replaced the DI pump with a reconditioned one. Car starts and idles fine around 800-1000rpm. (This didn’t happen previously) Seems to be stuck in limp mode. MIL Show faults 0403 and 0206 even replaced TPS. Any other resets or tricks needed to get out of limp mode?

 

[tweak'e]

0403 is ACCEL POS SENSOR
no 0206 listed but 0203 is ACCEL POS SW (F/C)

check the throttle assembly and if you have any throttle controller or chip installed.

edit: did you clear the codes after replacing the TPS?