JAFO's D22 Ride

[JAFO]

Hi all,

Well with the start of the Nav's 2nd year, another upgrade

Yesterday had installed an Ironman Constant Load Suspension Kit, so . . . added to the list.

So the list now shows:
* Icom 208H Amateur Radio - 'Done'
* UBCD396XT Scanner with UBC-RH96 remote Head - 'Done'
* Portable Radio Charching Docks - 'Done'
* Mobile Phone Kit - 'Done'
* Tow Bar - 'Done'
* ARB Canopy/Roof Bars & Basket - 'Done'
* Dual Battery System - 'Done'
* Temp Storage System in - 'Done'
* Ironman Under-body protection plates - 'Done'
* Assessory (12v) Switch box installed - 'Done'
* Canopy camp lights installed - 'Done'
* Security System (Incl - Central Locking/Turbo Timer) installed - 'Done'
* GPS/Multi Media System - Done
* Day LED Running Lights
* Ironman Constant Load Suspension Kit - Done

Still to add:
- Home made Storage system ("time" hard to find)
- Snorkel
- Bullbar
- Winch
- Cruise Control

Slowly getting their

 

[JAFO]

Another add-on, and tomorrow another add-on to go with it

 

[JAFO]

Winch & Bullbar went on Friday and Yesterday . . .


Still to add:
- Home made Storage system ("time" hard to find)
- Snorkel
- Cruise Control

slowly getting there

 

[JAFO]

Over the past week I finally got around to doing my storage system.

500×300x270mm Under Deck Storage Box with trap door behind fridge
Fridge slide
Table srorage slot
1400×570x270mm Draw on 100kg Slide
20Lt Water Jerry can

Now, to carpet, varnish or just paint? That is the question.

Still to add:
- Snorkel
- Cruise Control

Nearly Done

 

[Trent Naudi]

Hi mate, sweet looking build I was just wondering how much do you think you've spent to build the drawer system minus te fridge ect
And did you consider a tub liner? If so why did you opt not to install one?
In my opinion it will look sweet carpeted with some steel cornering for added strength

Cheers - Trent

 

[JAFO]

Trent, so far I would say about $200. The Plywood was 3x 2400x1200x15mm sheets @ $56 each. I refitted my DIY fridge slide from my old system, and I already had the 1400mm Draw Slides, so saved myself about $150 - $200 there on the draw slides. Screws etc added up to about $30, so $200 would be about my spend so far