Tyre fitment on 2 inch lift

[Skebtor]

Hello, I have a D40 STX 550 2011 with a 50mm lift kit and was wondering what a good fit would be for that. I'm planning on getting some all-terrains but I don't know too much about tyre fitment so I wanted to see what you guys would think. Thank you.

 

[MANNING]

A general size used with a 50mm lift on the standard factory supplied rims is a 265 either 70/17 or 75/16

I went bigger from there but I had to change the rim offset to stop scrubbing when I turned the wheels

 

[Skebtor]

A general size used with a 50mm lift on the standard factory supplied rims is a 265 either 70/17 or 75/16

I went bigger from there but I had to change the rim offset to stop scrubbing when I turned the wheels

The wheels I've got right now are 265/50r20 so I'm probably going to buy new rims as well but thank you very much for your help.

 

[MANNING]

The wheels I've got right now are 265/50r20 so I'm probably going to buy new rims as well but thank you very much for your help.

I just threw into the calculator for the 17 inch rims - seems you'll get a better wheel doing this.. not sure tje is what you need or the style of driving your doing so a bit hard to give any further advise.

 

[MANNING]

If your happy with your width, go a smaller rim with more side wall.

 

[Skebtor]

If your happy with your width, go a smaller rim with more side wall.

Thank you for the help, that's probably what I'll end up doing.

 

[Aidan 550]

The 550 needs 17 inch rims to clear the front calipers.
I have a 2 inch lift and went for 265/70/17 and they fit perfectly.