Running wires through firewall

[Figgy]

Hi Guys, I have an 03 D22 and I'm wiring up 2 lightbars for it. One for the back and one for the front. I cant find a suitable place to run my wires into the cab for switches. I'm using 6mm dual core wire.
I'm hoping someone has had this issue before and found a way around it. There is 1 gromet that I ran my coax through but its not quite big enough.

Cheers in advance.

 

[jonney]

on my 2014 model d22 looking under bonnet from the passanger side at the firewall nearly behind the engine you will see a steel plate thats held on by 2 bolts, undo the bolts and the plate comes off leaving a good sized opening for wiring to go into the cabin under dash. you can drill a good sized hole in this plate to fit a rubber grommet then feed the wires through.

 

[amber.2]

I ran my spotlight wiring through where the Bonnet release cable came through the firewall

 

[Oldie]

On my 03 D22 there are 2 rubber grommets in the firewall, one on the drivers side and one on the passengers side and I have my aerial cables running thru them.
you might have to cut the grommet a bit to get the cable thru.

 

[Jarone]

On my 03 D22 there are 2 rubber grommets in the firewall, one on the drivers side and one on the passengers side and I have my aerial cables running thru them.
you might have to cut the grommet a bit to get the cable thru.

This is what I have done also ^

However i just wanted to mention you dont need 6mm wire running all the way to the switch! that is what relays are for