Rear Pinion Angle Correction

[OneMofo]

Il be looking into some edges then going from there. Droneing is driving me nuts.

 

[Smarto]

Il be looking into some edges then going from there. Droneing is driving me nuts.

Did you end up getting the wedges? If so what degree and how has it ended up?

 

[vicszd30]

Still working on mine, put in a 15mm tail shaft spacer to push the centre bearing back into place but i'm still getting what I now think is a diff shudder... I cant win ffs. it cant be the clutch- iv'e had it out twice, second time got the works so it has to be the diff- it's not there from take off it comes in a touch latter like a tail shaft bouncing round.

 

[Smarto]

Still working on mine, put in a 15mm tail shaft spacer to push the centre bearing back into place but i'm still getting what I now think is a diff shudder... I cant win ffs. it cant be the clutch- iv'e had it out twice, second time got the works so it has to be the diff- it's not there from take off it comes in a touch latter like a tail shaft bouncing round.

Where did you get the tail shaft spacer from? Did u happen to take any photos of the centre bearing when it was pulled to the rear slightly? I think mine is pulled to the rear also but I didn't take any notice of what it looked like before hand. Did u end up using the wedges?