Ecm removal.

[Heath Robertson]

Yd 25 D40 2008.stx Spain model that's rhd.

I'm following the manual to diagnose a fuel rail pressure sensor issue. And wanted remove/ unplug the ECM and check for continuity etc. but can't see how to unplug the loom from ECM. There are the two levers. Top one folds away and down..

How to you undo the other half? Any tricks without removing everything in the corner of engine bay? Am I missing something or is it just a pita?

 

[Heath Robertson]

So I was not using enough pressure. The ECM plug was very stuck on, but with a lot of wiggling was able to remove the top half that contains all the wires from the frps to ecu.

Testing for continuity on the other hand wasn't successful... The loom connections are very small and didn't want to damage and connector to ecu wiring.

Anyone testing frps wiring this I'll post the manual page a bit later..