Search results

I'll check that as soon as I can. The engine has been apart and rebuilt, so there shouldn't be any blocked hoses since I've cleaned everything. There is no visible smoke from the exhaust. It seem clean. No odd sounds from the engine either. No loss of power that I've noticed. Oil consumtion I...

From what I've found and read so far, every supporting structure in the front is identical. And parts will swap right over using the same bolt holes. Car frame and suspension isn't identical, but everything you bolt exterior parts to on the body are. So I would assume the cooling performance...

I have rebuilt the engine. New top. New pistons. EGR deleted. Intake and intercooler fully cleaned. This is where I am at after letting the car idle for about 10 minutes, then revving the engine a few times. I removed the piping closest and cleaned them again. Not a huge amount of oil. Do I...

The benefit of this knowledge is valuable I think. Some spare parts should be shared, and it gives options for fender styles. The Xterra has more of a boxy wheel arch instead of a standard round one. I atleast think that the bodylines can look neat, in some configurations. The images posted...

A Nissan Xterra 2002-2004 front can be bolted to a Nissan Navara D22 and vice versa. (Hood, fenders, grill, headlights, some interior parts .etc) (applies to some other models too) It's a thing I've seen on some US forums. When they mix their Nissan Frontier (D22) and an Nissan Xterra they...

I just cleaned out my intercooler and intake manifold of what I am pretty sure wasn't just a 5mm layer of "black air". Thanks EGR and PCV. The reason to keep the EGR would be for emissions inspection. Living in Sweden, btw. As I see it, the engine would be easier to wrench on without the EGR...

I have been thinking of doing exactly this just last weekend. I take it you just used an anglegrinder and cut the upper EGR part off. Please do post a picture or two. My plan was to do this on my D22 model, because then all the EGR pipes would be fitted with only 4 bolts and the valve cable. I...