Ecm removal.

shop deals on amazon
Shop deals on ebay
Advertise with us
Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Heath Robertson

Heath Robertson

Member
Joined
May 9, 2024
Messages
20
Reaction score
1
Yd 25 D40 2008.stx Spain model that's rhd.

I'm following the manual to diagnose a fuel rail pressure sensor issue. And wanted remove/ unplug the ECM and check for continuity etc. but can't see how to unplug the loom from ECM. There are the two levers. Top one folds away and down..

How to you undo the other half? Any tricks without removing everything in the corner of engine bay? Am I missing something or is it just a pita?
 
So I was not using enough pressure. The ECM plug was very stuck on, but with a lot of wiggling was able to remove the top half that contains all the wires from the frps to ecu.

Testing for continuity on the other hand wasn't successful... The loom connections are very small and didn't want to damage and connector to ecu wiring.

Anyone testing frps wiring this I'll post the manual page a bit later..
 

Similar threads

Bigbark
HOW TO DO A D22 TIMING CHAIN
Replies
4
Views
4K
Robbo12
R
T
How the Navara was born and progressed
Replies
3
Views
2K
Tms40
Tms40
M
ZD22 fuel injector pump fault code 0707
2
Replies
35
Views
15K
Rhino1174
R
justbruce
My engine rebuild
Replies
9
Views
7K
Czechmate
Czechmate
ShortyNavros
How-to Guide: ZD30 Air Intake Manifold Removal
2
Replies
24
Views
46K
karl
karl

Latest posts

Back
Top