Where to feed UHF cable through firewall

[Schickies]

Hi all,
I have just purchased a 2008 D22 and need some help to where I can feed my UHF aerial cable through the firewall???

 

[KraftyPg]

Welcome to the forums. I'm sure this has been answered a heap of times before, have you tried searching?

 

[Jaws]

There is a gromit on the drivers side comes through above the excelerator

 

[Dave]

^ Thats what I used.

 

[Dion]

Mine runs along inside the driver's side quarter panel, and then in through an extra hole I poked in the drivers door loom grommet. Good spot, easy to get at it all for the install.

 

[d22dave]

I went passenger side , Only because it powers of my second battery, Up high near the fuel filter comes in behind the glove box,

 

[mitch92]

I have mine on passenger side, and then i have two seperate cables on the drivers side grommet too. Drivers side you need to pull off the plastic above the wheel to get at, passenger side is just open the bonnet.

 

[wildlifeDriver]

I used the hole where the air con lets water out . passanger side just under glove box area

 

[sparra04]

i ran mine through pass side inner gaurd then through door gromett

 

[d22dave]

Welcome to the forums. I'm sure this has been answered a heap of times before, have you tried searching?

At least it wasn,t what tyres for my d40

 

[nakedape]

Are there any grommets going out the back of the cab? I'm wanting to shift one or two aerials to the bar work & am looking for a neat solution.

 

[SIMASH!!!]

mine goes through the passenger side firewall grommet south west of the fuel filter on a 3L then run it along the top of the fender and through the headlight well

 

[SIMASH!!!]

Are there any grommets going out the back of the cab? I'm wanting to shift one or two aerials to the bar work & am looking for a neat solution.

1/2 ' drill bit and a grommet from nissan, make sure you paint some primer on the hole after wards

 

[joshman]

Pull the centre console out and put it under there with the hand brake line, at least that how I'm gonna do my centre console switches when it comes time to use them.

 

[Schickies]

Thanks all for your help. Most appreciated.