Replacing heater core

[Notso]

G'day all I have the dash of my 2003 D22 out putting in a new heater core (copper and brass) instead of alloy is there any thing I should do while I have it out ? any suggestions would be great but be nice

 

[Been a while]

Howdy mate, how did you go with this job.. Also where did you get the core? Mines leaking into the cab ...

 

[Boogieboots]

I imagine it is too late now but....
http://www.navara.asia/showthread.php?t=35891&page=2

 

[Been a while]

I imagine it is too late now but....
http://www.navara.asia/showthread.php?t=35891&page=2

Howdy man, thanks for that, I'll have a read later.. with mine, seems I'm a little heavy with my hand on the hose clamps..

Stinking alloy feed pipes to the heater core have collapsed a touch on the in and out, and because the hose was hard up against the rubber grommet in the firewall - when it did dribble it ran into the cab..
I'm hoping !
Floorings out to dry so I'll keep an eye on it for a few, I didn't risk trying to work the pipe back in to shape - used a good silicone to glue them on and when that sets I'll use the hose clamps on them..

Just goes to show there is a reason for those hose clamps Nissan use eh, tricky little Asians...

Was nOt looking forward to pulling that dash Hoping it's a fix...