Looking to make a draw system for my d22

[sanchod22]

Has any one made one on here just want to run a 2nd battery , compressor , inverter , fridge and have storage as well if anyone has ideas , drawings or any advise sure would help as i aint no chippy but have the tools and will to try make it happen, i em going to use marine grade sheets, marine carpet not sure where to get the draw rails from im located in western sydney if any one knows where i could get some good quality ones price wouldnt matter as long as they are good, thanks hope to get some feed back!!

 

[Joshp82]

get some hdpe for your runners. its the same stuff drifta use and a hell of a lot cheaper than the metal runners.

 

[sanchod22]

thanks will look into it are they like rollers with bearings?

 

[LLadnar]

Check out Blacknavs garage or build thread, he built his own or Sparra see his build thread he built his with Blacknavs help,

 

[Joshp82]

thanks will look into it are they like rollers with bearings?

no they are like the white bread board material. a spray of silicone spray very now and them will keep them sliding

 

[qqc d22]

use rhs or angle and rollerblade bearings and make slide. rhs or angle $10 set of old roller blades $buggerall. works well