Search results

Well after reading the whole thread and having my 09 with 50k blowing smoke and lacking low down power, I thought what the heck. Grabbed some gal steel from Bunnings 0.95mm cut and drilled and installed. Real easy job as all bolts are easily accessable - didnt even have to remove battery. So...

As per one of my other posts I installed an RFID remote central locking kit. Got some tips and diagrams off Dave and got it installed without much issue. I also installed a reversing camera and a new dvd head unit. Was all a bit scary stripping apart a 1 week old car to install it all though...

Ok. Here's the results.... I filled my jerry can with diesel and set on my highway journey with the needle just above the line at E. After about 10 K's the light came on victory: So it does work. Bottom line is mine comes on with just under 10l left in the tank. Should be good for 100km of...

Yeah but eh point of the whole thing is getting the #@%$ light to come on so I dont run out :) I was only going to take it a bit further just to see if the light does come on and hopefully not run out. From what has been said it looks like about 10 litres left in the tank the light should...

I may have just missed running it low enough to go on. I now would really like to know if it does work so I might run it under the E mark and see. I havent had a diesel before but I was told I must pump the primer on the fuel pump to prime before I start it. Not sure how I know I have pumped it...

Sounds like it should work then. I was just thinking the alarm was an electrical change to the vehicle and they might use that as an excuse to void warranty. So where is the gauge when the light comes on. I took mine down so the needle was sitting across the E line. I see thats where DeeJay...

Does yours have the double batteries fitted? Maybe they offset the cost of putting them in :) Not sure if I should get it checked under warranty. That would mean I would have to get my car actually serviced at Nissan :( and I have fitted an alarm to it so I am sure they would say it was...

Yeah you would be surprised how many things have been disabled in the D22. Only the driver door switches on the internal light for example. All to save a couple of bucks on the switches in the other doors!

I know my model has a fuel light as it lights when I put the dash on diag but are they actually connected in the 2009 model? The reason I ask is that I ran the tank right down to find out when it goes on and it didnt. When I refilled I put 65 litres in the tank which means only 5 litres left...

Got my alarm fitted. Tapped into some similar connections as the genuine kit. Installed an Actuator to the drivers door from Jaycar then cabled up into the circuit from the passengers door. Drivers door connector doesnt have the wires :( All working and I installed a reversing camera in th...

Yeah Nizzbits has been great. Sent me the install instructions to check out. If anyone else was wondering the genuine kit fits via 3 T harness adapters. 1 On the ignition circuit 1 on the Indicators circuit 1 on the light switch for the drivers door The actuator fits to the drivers door and...

Was having a look at the wiring this afternoon with the WS manuals. Seems like they may be a bit different in the 2009 model to what I have in the book. Might be helpful if I get the genuine kit as I will need an actuator. Anyone know where I can get one cheaply?

I'll have a look on the weekend and see what I can come up with. Might be OK during light rain but with the recent rain we have had in QLD it cant drain quick enough.

Where did you get the additional bars from Azza?

Maybe if I put a better or higher lifting bar?

Tonneau fills with water? Recently got a new D22 with Tonneau cover fitted. Its been raining fairly heavily here but I found the water doesnt roll off but pools to the point of almost snapping off the little tie down cords. It has the rail fitted underneath which I thought would make the...

I have ordered a K9 Sombra RFID alarm form the states. It should be pretty cool when fitted. It automatically locks and unlocks the doors of the car by proximity to it. I am hoping I will be able to get the right advice to help me fit it myself rather than taking it to an auto leccy. I am...

Thats good/bad news. Do you think an after market actuator would fit into the same area or would I need to make some mods? Also how does the remote receiver connect? does it just go inline onto connector M3? Does it also hook to M7 for Indicator flash? Appreciate your help :)

I have bought a Remote central locking alarm and want to install it to my truck. Looking at the workshop manual I should be able to trace the wires down but I am not sure if I need to retro fit a drivers door actuator. There is a genuine kit from nissan to remote lock these - does anyone know...