Search results

Stockton

Tail gate mine rocks side to side need to shim the hinges

Thanks mate will give it a go

I have suspicion my cvs are gone I've spent all arvo going over every nut and bolt and all good there is little to no play in the shaft but when I turn at slow speeds and turn the wheel at the same time it's like a cracking noise mainly on the drivers side I have about 3"s of lift and the cv's...

I thought the pcd was the same just the offset

Hey guys just wanted to no if 16" +20 offset rims will fit a 2012 st

Was the same before I put the spacers in

And I have 60mm of down travel

If I try and lift the front up under the lower control arm it just starts to flex the back. Deffently need weight in the front

Thanks for the advice but I don't see how the spacers on top of the strut limits down travel unless it hits the coil hat ( in my case it doesn't ) I'll measure my down travel when I get home but I no before I put extended ball joints in it use to hit the coil hat now the shock fully extends Do...

Are k I no it compresses cause when I hit a cause way or something it's fine doesn't bottom out and feels smooth

How much down travel should I have in the front ?

I'll disconnect the sway bar and give it ago this arvo

I no it flexes well at the back but not to much in the front properly because of the big ass sway bar

I don't think it's hitting anything I'll double check. But what you mean by compressing the shocks on the front by lifting them wouldn't that extend them

Problem is it spends 90% of the time on the road more then I'd like

Yeah mainly up the front

That's what I Mean it feels as if it has constant load springs I don't have a bull bar and never carry heavy loads. I've Checked the numbers on the spring with ironmans website and they should be just the peformance ones. It's fine off-road I do change the pressures when I need too I've...

Lately my trucks been real rough the last couple of months it's a 2012 st Mods are iron man 2" lift with 25mm spacers to level it out after it sagged and some extended ball joints ( waiting on performance suspensions uca ) to fix camber issue The mods have only been done for a few months...