Engine Guard, overheating engine alarm. Who has one, where did you fit sensor?

[Been a while]

Howdy all, as heading states, who has one?

More importantly, where did you place the sensor on the head?

 

[Horatius]

There's a very convenient bolt hole on the head near the centre firewall grommet. Tried a few different attachment points, but that's the one I use.

 

[Been a while]

There's a very convenient bolt hole on the head near the centre firewall grommet. Tried a few different attachment points, but that's the one I use.

Thanks man, I'll Have a look for it...

 

[[email protected]]

There's a very convenient bolt hole on the head near the centre firewall grommet. Tried a few different attachment points, but that's the one I use.

What Motor?

 

[Horatius]

What Motor?

ZD30.

 

[Been a while]

ZD30.

ZD30..

 

[Been a while]

There's a very convenient bolt hole on the head near the centre firewall grommet. Tried a few different attachment points, but that's the one I use.

Got it, yup,that will do fine! Cheers....

 

[Tms40]

I’ve just purchased one. Still to arrive but can anyone suggest where to place it in 2014 D40 2.5
If anyone has one can you please post a pic

 

[Erick]

Bolt directly to the head toward back of motor if possible. Stay away from exhaust. Don’t bolt to any casting that sticks out from the head.

 

[Tms40]

Thanks mate

 

[Tms40]

Installed. Normal driving after an hour it sits steady on 77-78 degrees. I haven’t pushed it yet with any hard driving. Alarm is set at 100.

 

[Erick]

Sounds like u have it at a good spot. Alarm is usually ten to fifteen degrees over normal